VCS VIP 1000 Manuel d'utilisateur télécharger pdf (Page 68)

68 en | Appendix VIP XD

DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems

Assigning an IP Address

Before you can operate a VIP XD in your network you must first assign it an IP address that is

valid for your network.

The following default address is preset at the factory: 192.168.0.1

1. Start a terminal program such as HyperTerminal.

2. Enter the user name service. The terminal program displays the main menu.

3. Enter command 1 to open the IP menu.

4. Enter 1 again. The terminal program displays the current IP address and prompts you to

enter a new IP address.

5. Enter the desired IP address and press Enter. The terminal program displays the new IP

address.

6. Use the displayed commands for any additional settings you require.

Reboot

Briefly interrupt the power supply to the VIP XD for a reboot (disconnect the power supply

unit from the mains supply and switch on again after a few seconds).

Additional Parameters

You can use the terminal program to check other basic parameters and modify them where

necessary. Use the on-screen commands in the various submenus to do this.

NOTICE!

You must reboot to activate the new IP address, a new subnet mask or a gateway IP address.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Pas de commentaire

VCS VIP 1000 Manuel d'utilisateur Page 68