VCS VIP 1000 Guide de l'utilisateur télécharger pdf (Page 103)

VIP 1000 103

Hardware Connections 10

Hardware connections between VCS units

A VIP sender, connected to a camera, and a VIP receiver, connected to a

monitor, can be linked together or to other VCS units easily via an Ethernet

network. This makes it possible to establish connections over large distances

with little effort for installation or cabling.

Installation

The VCS units are designed to connect with one another automatically when

correspondingly configured. The only requirement is that they are both part of a

closed network. Proceed as follows to install the units:

– Connect the units to the closed network using Ethernet cables.

– Connect them to the mains supply.

Note

Make sure the units are correctly configured for the network environment

and that the correct IP address of the remote unit that is to be connected in

case of alarm is set on the configuration page Alarm connections (see

page 54 for the sender and page 81 for the receiver).

Establishing the connection

There are three options for establishing a connection between a VCS sender and

a VCS receiver in a closed network:

] when an alarm signal is given,

] using a terminal program or

] using a Web browser

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 125 126

Pas de commentaire

VCS VIP 1000 Guide de l'utilisateur Page 103