VCS VIP 1000 Guide de l'utilisateur télécharger pdf (Page 24)

Installation Chapter 4

24 VIP 1000

] Enter only one command at a time.

] After entering a value (such as an IP address), re-check the entry before

pressing the Enter key to send the data to the VIP.

Assigning an IP address

To operate the VIP on your network, you must assign it an IP address that is

recognized by the network.

The following default address has been pre-set at the factory:

Sender: 192.168.0.1

Receiver: 192.168.0.2

– Start up a terminal program such as HyperTerminal.

– Enter service as user name. The main menu will be displayed.

– Enter i to open the IP menu.

– Enter i once more. The current IP address will be displayed, and you will be

requested to enter a new IP address.

– Enter the desired IP address and press [ENTER]. The new IP address will be

displayed.

– If necessary, enter s and a new subnet mask.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 125 126

Pas de commentaire

VCS VIP 1000 Guide de l'utilisateur Page 24