VCS VIP 10 Guide de l'utilisateur télécharger pdf (Page 20)

Installation Chapter 4

20 VIP 10

– Connect a line level audio source to the appropriate terminals on the orange

terminal block of the sender and check that the connection is secure.

– Connect a loudspeaker to the appropriate terminals on the orange terminal

block of the receiver and check that the connection is secure (for pin

assignment see page 111).

Switching on/off

Power connection

A plug-in mains adapter is included with the VIP package. The VIP does not have

a mains switch. The unit is ready for operation as soon as it is connected to the

mains supply.

Warning!

Use only the plug-in mains adapter provided for operation of the VIP. Where

necessary, take appropriate measures to ensure that the mains supply is

protected against voltage surges, spikes or brownouts.

Warning!

Do not connect the VIP to the power source until all the other connections

have been made.

– Connect the cable of the mains adapter to the orange terminal block of the VIP.

– Plug the mains adapter into a fused power socket. The unit is ready for

operation as soon as the "operating status" LED stops blinking red during

start-up and becomes yellow.

If the network connection is in order, the green "network connection" LED is also

lit. The blinking orange "data transmission" LED indicates data traffic on the

network.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 121 122

Pas de commentaire

VCS VIP 10 Guide de l'utilisateur Page 20